36 – English
5.3.5 Safety system
The engine can only be started when the following
conditions are met:
• The cutting deck is lifted and the parking brake is
applied.
The engine must stop under any of the following
conditions:
• The cutting deck is lowered and the operator
rises from the seat.
• The cutting deck is lifted, the parking brake is not
applied and the operator rises from the seat.
To do a check of the safety circuit, try to start the
engine with one of the conditions above not met.
Change the conditions and try again. Do this check
daily.
Microswitch pedal carrier
1. Remove the cover over the frame tunnel.
2. Adjust the microswitch so that it clicks when the
parking brake is depressed about 40 mm / 1.5”.
NOTE: The spring on the parking brake cable
can be unhooked to improve accessibility.
5.3.6 Replacing the light bulbs
For information about the bulb type, see “6.1
Technical data” on page 70.
1. Loosen the screws on the cover and lift it up.
2. Disconnect the cables from the broken lamp.
3. Replace the lamp and connect the cables to it.
4. Attach the cover and tighten the screws.
Electrical system
To Next Page
Loading...
Need help?
General
