6 – English
2 Delivery and service
2.1 Service schedule
WARNING: Do not do service on the engine or cutting deck unless the conditions that follow
are met:
• The engine is o.
• The parking brake is applied.
• The ignition key is removed.
General maintenance not described in this workshop manual or operator's manual.
n Described in this workshop manual.
m Described in the operator’s manual.
Care Daily mainte-
nance before
At least
once a year
Maintenance
interval in hours
25 50 100 200
Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
Clean the chassi
m
Clean under the cutting deck
m
Clean around the muer
m
Make sure that the engine cooling air intake is not
blocked
m
Make sure that the hydraulic oil cooling is not
blocked. (RC 320Ts AWD model only)
m
Make sure that the safety devices are not defective.
m
Examine and test the brakes
m
Make sure that the sensor for cellector full works
correctly.
m
Do a check of the engine oil level
m
Do a check of the oil level in the transmission
m
Do a check of the steering wire
m
Examine the blades in the cutting deck
m
Clean the cutting deck, under the belt covers and
under the cutting deck
m
Examine the headlights
m m
Make sure that the tire pressure is correct
m m
Do a check of the parking brake
m
Change the engine oil
m
Change the oil lter
m
Clean the air lter
m
Change the air lter
n
Change the fuel lter
n
Do a check of the parallelism of the cutting deck
n n
Lubricate the belt adjuster
n n
Delivery and service