12. Set Slope Factor
You enter the relative flatness of your landscape.
• Slope factors are aimed at reducing runoff and maximizing
water intake by the plants’ roots.
• Slope factors will affect the duration of each water cycle and
the number of cycles required to apply water.
• The steeper the slope the greater the number of cycles and
the lower the runtime per cycle.
13. Set Sprinkler Location
You enter a sprinkler location if the sprinklers are on a slope.
Note: If the slope is “0”, you will not be allowed to select a
location.
14. Set Usable Rainfall
This feature only works with the WeatherTRAK Rain Service.
Note: Specific values are entered for each station. To speed up
the entry process, you can use the COPY feature to copy
information from one station to another and then edit as
required.
To Begin Fully Automated Programming:
Set Station to Program
1. Turn the Function Selector knob to PROGRAM.
You will see the following display:
2. Turn the Lower Line knob to the desired station. You have the
following choices:
• STA 1, 2, 3, etc. up to the maximum active station number
that you entered during SETUP.
To Next Page
Loading...