HydroPoint WeaterTRAK ET plus - Page 39

Set Program Mode
1. Turn the Upper Line knob until you see:
2. Turn the Lower Line knob to select “Fully Automated” from the
following choices:
• Fully Automated (Default Setting),
• User Programmed-With ET,
• User Programmed-NO ET or
• OFF.
Note: Each of the program modes is shown sequentially.
Set Schedule
1. Turn the Upper Line knob until you see:
2. Turn the Lower Line knob to select one of the following choices:
•Aor
•B.
Use Water Window
1. Turn the Upper Line knob until you see:
This tells the controller whether this station should use the water
window you entered in SETUP. The controller calculates the
end time.
USE WATER WINDOW STA 01
Yes (end time 11:01pm)
SET SCHEDULE STA 01
Sch A
SET PROGRAM MODE STA 01
Fully Automated
Programming Your WeatherTRAK ET plus 35