2. Turn the Lower Line knob to choose:
• Yes (end time) or
• No.
Set Sprinkler Type
1. Turn the Upper Line knob until you see:
The lower line of the display shows the default setting.
2. Turn the Lower Line knob to choose one of the following
sprinkler types:
• Spray Head (Default Setting),
• Full Circle Rotor,
• Part Circle Rotor,
• Mixed Rotors,
• Full Circle Impact,
• Part Circle Impact,
• Mixed Impacts,
• Stream Rotors,
• Bubbler,
• Drip Emitter or
• Stream Spray.
Set Precipitation Rate
1. Turn the Upper Line knob until you see:
Note: This setting should match the precipitation rate that you
gathered using the Site Data Gathering process on page 95.
2. Turn the Lower Line knob to choose the first digit of the
precipitation rate desired:
• 0 to 9.
To Next Page
Loading...