Set Usable Rainfall
1. Turn the Upper Line knob until you see:
The lower line of the display shows the default setting of
“Inactive.”
2. Turn the Lower Line knob to choose one of the desired
percentage of estimated rain to be on this station.
• Inactive to 100% in 25% increments (default setting:
Inactive).
Note: By default this feature will be inactive. WeatherTRAK Rain
Service is only available in select regions and must be activated
by HydroPoint Customer Service. If not activated, no percentage
can be set. This feature is not the same as the RAIN PAUSE
function. Please see “Using Rain Pause” on page 65 for more
information.
To End Automatic Programming
1. Turn the Upper Line knob until you see:
2. Turn the Lower Line knob to start the next station program
schedule, or you can turn the Function Selector knob to other
programming functions.
To speed up the process of entering this information on other
stations, you simply use the COPY feature to copy the data from
one station to either select stations or to all stations. You can then
edit to make changes to the stations as required. Please see
“Copying” on page 49 for more information.
You can also directly program additional stations.
To Next Page
Loading...