To Begin User Program:
Set Station
Turn the Function Selector knob to PROGRAM.
Set Program Mode
1. Turn the Upper Line knob to “Set Program Mode.”
2. Turn the Lower Line knob to “User Programmed--With ET,” as
in the display below.
Set Cycle Time
1. Turn the Upper Line knob until you see:
First, you will set whole minutes. Then you will set tenths of
minutes.
For this example, change the cycle time to “25.8 minutes.”
2. Turn the Lower Line knob to the desired minutes (Turn to 25):
• 00 to 99 (Default Setting: 05.0).
3. Turn the Upper Line knob until you see:
You can now change the lower line of the display to show the
desired tenths of minutes.
To Next Page
Loading...