4. Turn the Lower Line knob to the desired tenths of minutes
(Turn to 8):
• 0 to 9.
This is what the display looks like when the cycle time is set to
“25.8 minutes.”
Set Number of Cycles
1. Turn the Upper Line knob until you see:
2. Turn the Lower Line knob to the desired number of cycles (00
turns station OFF):
• 00 to 20 (Default Setting: 01).
Set Soak Time
1. Turn the Upper Line knob until you see:
2. Turn the Lower Line knob to the desired soak time:
• 0 to 480 in 10-minute increments (Default Setting: 30).
Note: Due to the nature of some soils, it is important that you
apply water in short cycles to prevent irrigation water from
running off the landscape area onto pavement, roadways or
other areas.
To Next Page
Loading...