“No Change” will not alter the schedule. This is what the display
looks like when Station 3 is set to “Decrease Irrigation -05%:”
Any stations that are in the “User Programmed” mode will look
like this:
Repeat this pattern of selecting a station to ADJUST and the desired
percentage until complete. After a station and the percentage change
is set, the controller will calculate a new irrigation schedule for that
station.
To see a station that has an ADJUST value, turn the Function Selector
knob to REVIEW. The display will look like this:
Reading from left to right, the upper line shows:
• STA 01 Station Number
• 09.1 MIN Runtime in Minutes
• 02X Number of Cycles
• AUTO Program Mode
Reading from left to right, the lower line shows:
• Wk1: -MTW-FS Watering Days for Week 1 (current week)
• 10% Adjust Setting
• Soak 15 Soak Time
Note: If increasing the irrigation by the ADJUST function exceeds the
maximum calculated cycle time, a cycle will need to be added and
the adjusted cycle time will be reduced. (The maximum cycle time
applies to an amount of water up to the runoff point due to soil
saturation.)
To Next Page
Loading...