Hypertherm Powermax 65 - Page 137

TroubleshooTing and sysTem TesTs
powermax 65/85 Service Manual 5-11
Measure resistance
from
200 – 600 V CSA power
board location
400 V CE power
board location
Approximate
values
Work lead to nozzle J26 to black wire J27 to black wire 230kΩ
Work lead to electrode J26 to red wire J27 to red wire 15kΩ
Electrode to nozzle red wire to black wire red wire to black wire 230kΩ
Output to ground > 20 MΩ
If no problems were found during the visual inspection or the initial resistance check, and the power supply still does not
operate correctly, see the Troubleshooting guide.
Note: The Troubleshooting guide provides most probable causes and solutions. Study the system wiring diagram
and understand the theory of operation before troubleshooting. Before purchasing any major replacement
component, verify the problem with Hypertherm Technical Service or the nearest Hypertherm repair facility.
Black wire
Red wire
J28 CSA
J29 CE
J26 CSA
J27 CE
WORK
LEAD