Hypertherm Powermax 65 Service Manual

Parts
powermax 65/85 Service Manual 7-19
Machine torch consumables
Part number Description
Shielded
220817 Shield
220854 Retaining cap
220953 Ohmic retaining cap
220941 45 A Nozzle
220819 65 A Nozzle
220816 85 A Nozzle
220842 Electrode
220857 Swirl ring
Unshielded
220955 Deflector
220854 Retaining cap
220941 45 A Nozzle
220819 65 A Nozzle
220816 85 A Nozzle
220842 Electrode
220857 Swirl ring
Gouging
220798 65 A/85 A shield
220854 Retaining cap
220797 65 A/85 A nozzle
220842 Electrode
220857 Swirl ring
FineCut
1
220955 Deflector
220948 Shield
220854 Retaining cap
220953 Ohmic retaining cap
220930 Nozzle
220842 Electrode
220857 Swirl ring
1
The deflector (220955) is used only with the standard retaining cap (220854). The shield (220948) is used only with
the ohmic retaining cap (220953).

Hypertherm Powermax 65 Specifications

General

Open Circuit Voltage (OCV)	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Maximum Cut Capacity (Mild Steel)	1" (25 mm)
Input Voltage	200-600 V, 1/3-PH, 50/60 Hz
Output Current	20 – 65 A
Duty Cycle	50% @ 65 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Torch Lead Length	25 ft (7.6 m)
Maximum Cut Capacity (Aluminum)	5/8" (16 mm)
Severance Cut Capacity (Mild Steel)	1-1/4" (32 mm)
Maximum Severance Thickness	1-1/4 in (32 mm)
Gas Type	Air/Nitrogen
Torch Options	Hand Torch, Mechanized Torch