IAI PCON-C User Manual

134
If the actuator is moved in the order to positions 1  2  3  4, the actuator will operate differently
depending on whether or not shortcut is selected, as explained below.
When shortcut is not selected
When shortcut is selected
 Absolute unit (No.83 ETYP)
Parameter No. 83 sets whether or not an optional simple absolute unit is used.
Setting
Not used 0
Used 1
 Current-limiting value at standstill after missing work in push & hold operation (No. 91 PSFC)
This parameter defines the current-limiting value when the actuator is at standstill after missing the work in
push & hold operation.
Parameter No. 91 Description
0
Current-limiting value during movement
(An appropriate value has been set in accordance with the actuator
characteristics.)
1 Current-limiting value during push & hold operation
Point No. 1
Point No. 2
Point No. 3
Point No. 3
Point No. 2
Point No. 4
Point No. 4
Point No. 1
Point No. 1
Point No. 2
Point No. 3
Point No. 3
Point No. 2
Point No. 4
Point No. 4
Point No. 1

IAI PCON-C Specifications

General

Brand	IAI
Model	PCON-C
Category	Controller
Language	English