IAI RCON Series - Page 114

Quick Start Guide ~ RCON PROFINET IO Specification ~
p114
©2023 / IAI Corporation
STEP
３
STEP
１
STEP
２
Operation
Table
of
Contents
2
Operating Condition Setting and Adjustment
The operating conditions (AVD) can be set or adjusted with the procedures shown
below.
Input each value for A: Acceleration [%] / V: Velocity [%] / D: Deceleration [%]
in the “Operational Conditions (Forward Motion: Backward end → Forward end)”
(and press the “Enter” key after input).
(1)
A: Acceleration
AVD
V: Velocity
D: Deceleration
What is AVD
“Simple data setting” window
“Simple data setting” window
(1)
Input each
value +
“Enter”
In the example, input:
D: Deceleration [%]: 50
A: Acceleration [%]: 50
V: Velocity [%]: 60
Input each value for A: Acceleration [%] / V: Velocity [%] / D: Deceleration [%]
in the “Operational Conditions (Backward Motion: Forward end → Backward
end )” (and press the “Enter” key after input).
(2)
In the example, input:
D: Deceleration [%]: 100
A: Acceleration [%]: 100
(2)
Input each
value +
“Enter”
V: Velocity [%]: 77