5. Install the covers.
Note:
Install the optional audio kit at this time. See “Attaching the audio kit” on
page 49.
a. Attach the cable cover (1 in Figure 30) to the mounting bracket, snapping
the tabs on the sides of the cover into the small holes on the sides of the
mounting bracket.
b. Attach the mounting bracket cover (2 in Figure 30) to the back of the
display. Slide the tabs on the cover into the appropriate slots in the back of
the display and snap into place.
c. Position the trough cover (3 in Figure 30) over the trough of the integrated
pedestal. Press the trough cover until it snaps into place.
6.
Plug the power cord into an outlet and power on the system unit. See “Power
usage” on page 9.
7. Auto-adjust your screen for optimum viewing (see “Adjusting the image” on
page 53).
2
1
3
Mounting bracket cover
Cable cover
Trough cover
Figure 30. Integrated pedestal covers
Integrated pedestal instructions
Update November 2005
Chapter 2. Installing the IBM 4820 31
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
To Next Page
Loading...
