IBM 6400

Selecting And Running Tests
133
Splined shaft bearings
Tractors or tractor belts
• Underlines An underline pattern useful for identifying hammer bank
misalignment.
Hammer bank cover
Hammer tips
Paper feed belt or motor
Splined shaft bearings
Tractor bearings or belts
Selecting And Running Tests
To run Operator Print Tests you use the printer configuration menus, as
shown below:
Step Press Displayed Result Notes
1. Install the ribbon, load paper, and power on the printer.
2.
NOT READY
Printer must be in NOT
READY mode to access
the tests.
3.
OPERATOR MENU
UNLOCKED
Unlocking ENTER key
allows you to test the
printer.
4.
OPERATOR MENU
PRINTER CONTROL
First of series of
configuration menus.
5.
OPERATOR MENU
OPERATOR PRINT TESTS
Advances to the Operator
Printer Tests menu.
6.
OPERATOR PRINT TESTS
PRINTER DEMONSTRATION*
Advances to first option in
Operator Printer Tests
menu.
7.
OPERATOR PRINT TESTS
[TEST NAME]
Cycles through list of
tests. Stop when your test
displays.
8.
OPERATOR PRINT TESTS
[TEST NAME]
The test you selected
starts printing.
9.
NOT READY
The printer test stops
printing.
Stop
+
Scroll↑ Scroll↓
Menu
UNTIL
Scroll↑
Enter
UNTIL
Scroll↑
Enter
Stop