Paper Guide Assembly
229
Paper Guide Assembly
This procedure applies only to cabinet models.
Removal
1. Prepare the printer for maintenance (page 152).
2. Open the printer cover.
3. Loosen the three paper guide assembly hold-down screws (page 258,
Figure 44, item 6).
4. Slide the paper guide assembly to the left and lift it off the card cage.
Installation
1. Position the paper guide assembly offset slightly to the left on the card
cage with the keyway cutouts over the three loosened hold-down screws
(page 258, Figure 44, item 6).
2. Slide the paper guide assembly to the right, engaging the three hold-
down screws in the keyway slots. Slide the paper guide assembly to the
right as far as it will go.
3. Tighten the three hold-down screws (page 258, Figure 44, item 6).
4. Return the printer to normal operation (page 153).
To Next Page
Loading...
Need help?
General