168
Chapter 6 Splined Shaft Skew Adjustment
Splined Shaft Skew Adjustment
If lines of print are not parallel with the edge perforations on the paper,
perform the following adjustment.
1. Open the printer cover.
2. Loosen the screw (1) securing the adjusting link (2).
3. Adjust the link (2) by raising or lowering the horizontal adjustment knob
(3) to obtain print parallel with paper perforations. Tighten the screw (1).
4. Return the printer to normal operation (page 153).
Legend:
1) Screw
2) Adjusting Link
3) Horizontal Adjustment Knob
Figure 28. Splined Shaft Skew Adjustment
2
1
3
To Next Page
Loading...
