380
Appendix J Installing The Power Stacker
Installing The Power Stacker
NOTE: This procedure is for complete installation of the power stacker,
including cable assemblies and the stacker control panel.
1. Set the printer power switch to O (off).
2. Unplug the power cord.
3. Remove paper.
4. Loosen the three paper guide hold-down screws. Slide the paper guide to
the left and lift it off the card cage. (See Figure 72.)
Legend:
1. Paper Guide
2. Hold-Down Screw (3)
Figure 72. Remove the Paper Guide
1
2
To Next Page
Loading...
