18
Chapter 1 About This Manual
IMPORTANT
The word Important indicates information vital to proper operation of
the printer.
NOTE: A note gives you helpful tips about printer operation and
maintenance.
Printing Conventions In This Manual
Operator panel keys and LCD messages are set off from regular text in this
manual:
• Operator panel keys and indicators are printed boldface.
Example: Press the Cancel key, then press the Start key.
• Liquid Crystal Display (LCD) messages are printed in capital letters inside
quotation marks ( “ ” ).
Example: Press the Stop key. “NOT READY” appears on the LCD.
• Key combinations are denoted by the + (plus) symbol.
Example: Press Scroll↑ + Scroll↓
means
Press the Scroll
↑
key and the Scroll
↓
key at the same time.
Related Documents
To ensure complete understanding of important safety notices for technicians
whose native language is not English, the notices have been translated into
many languages in the
IBM 6400 Line Matrix Printer Safety Notices:
Form No.
G544-5389
.
This maintenance manual does not explain how to operate or configure the
printer. For that information, refer to the
Operator’s Guide and Setup Guide:
•
IBM 6400 Line Matrix Printer Operator’s Guide,
Form No. S544-5641
Illustrated instructions on daily printer operation.
•
IBM 6400 Line Matrix Printer Setup Guide
, Form No. S544-5640
Explains how to install and configure the printer.
•
IBM 6400-C05/C5P Line Matrix Printer Setup Guide
, Form No. S544-
5684. Explains how to install and configure the Hanzi printer.
•
Coax/Twinax Multi-Platform Interface Option Installation and Operation
Guide,
Form Number S246-0149
Information pertaining to printer control languages, emulations, and control
codes is in the applicable
Programmer’s Reference manual:
•
IBM 6400 ASCII Programmer’s Reference:
Form No. S544-5635
•
IBM 6400 CTA Programmer’s Reference:
Form No. S544-5636
•
IBM 6400 IPDS Programmer’s Reference:
Form No. S544-5637
•
IBM 6400-C05/C5P Programmer’s Reference-LQ1600K:
Form No. S544-5683
Information pertaining to graphics programming is in the applicable
User’s
Manual:
To Next Page
Loading...
Need help?
General