342
Appendix E Prepare The Printer for Inspection
Prepare The Printer for Inspection
To prepare the printer for a safety inspection, read the safety notices below,
then do the following steps.
1. Have the operator take the printer off-line.
2. Power off the printer.
3. Unplug the printer power cord from the customer’s power outlet.
Inspect Mechanical Parts
Top Cover And Cabinet Doors
1.
Inspect the top cover:
a. Open the top cover. On cabinet models, make sure the gas spring
assembly holds the cover up in the open position.
b. Make sure the window is not cracked or broken.
c. Make sure the seal around the top cover is not cracked or broken.
d. Make sure there are no exposed or sharp edges.
e. Make sure the wireform paper path is undamaged.
f. Make sure the electrostatic discharge (ESD) fingers are not loose or
damaged. Make sure they touch the contact strips on the frame when
the cover is closed.
g. Close the top cover. Make sure the operator panel is centered in the
opening of the cover.
2. On cabinet models, inspect the front and rear cabinet doors:
a. Make sure the seals and magnetic strips are not loose or damaged.
<3> Hazardous voltages are present in the printer with the
power cord connected to the power source. Switch off
printer power and unplug the printer power cord before
proceeding.
<4> Do not connect or disconnect any communication port,
teleport, attachment connector, or power cord during an
electrical storm.
<5> Power off the printer and disconnect the power cord
before
connecting or disconnecting a communication port,
teleport, or attachment cable connector.
To Next Page
Loading...
Need help?
General