List Of Adjustments
183
Ethernet Initialization
To initialize the Ethernet interface, do the following steps:
1. Power on the printer.
2. Wait for “READY / ETHERNET ADAPTER IS READY” to display on the
LCD.
3.
If the Ready indicator is on, press the Stop key. The printer must be in
the NOT READY state to do this procedure.
4.
Press Scroll↑ + Scroll↓
+ Return + Enter. (Press all four keys at the
same time.) “SERVICE / PRINTER MECHANISM TESTS” appears on the
display.
5.
Press Scroll↑ + Scroll↓ to unlock the Enter key.
6.
Press the Scroll↑ or Scroll↓
key until “SERVICE / PRINTER MGMT”
appears on the display.
7.
Press Enter. “PRINTER MGMT / DIAGNOSTIC PORT” appears on the
display.
8.
Press Enter. “DIAGNOSTIC PORT” (and the current diagnostic port
setting) appears on the display. If the current setting is “DEBUG
ETHERNET*”, go to step 11.
9.
Press Scroll↑ until “DIAGNOSTIC PORT / DEBUG ETHERNET” appears
on the display.
10.
Press Enter. An asterisk (*) appears next to the selection, indicating it is
now the diagnostic port.
11.
Press Scroll↑ + Scroll↓ to lock the Enter key.
12.
Press Stop to exit the menu and put the printer in the NOT READY state.
13.
Power off the printer, wait a few seconds, then power on the printer to
activate the new diagnostic port.
To Next Page
Loading...
Need help?
General