IBM 6400 - Page 414

414
cable routing, 287
ground path, 341
interconnection and cables, 287
Dimensions
printer, 329
Dipswitches
10/100Base-T, 55
Display (LCD)
list of messages, 62
Display messages, list of, 62
Display messages, printing conventions, 18
Documents related to this manual, 18
Doors, cabinet, reversing, 206
DRIVER CIRCUIT BAD, 100
Duty cycle, 336
E
EC (Engine Controller, CMX board), 49
Electrical characteristics, 330
End of Forms Adjust
procedure, 169
ENERGY SAVER ACTIVE, 100
Energy Star compliance, 329
Engine controller (EC), 49
Environmental characteristics, 329
ERROR
DC PROGRAM NOT VALID, 178
DRAM AT ADDRESS, 100
DRAM AT ADDRESS XXXXXXXX, 178
DRAM NOT DETECTED, 100
EC PROGRAM NOT VALID, 178
EC STOPPED AT STATE XXXX, 178
FLASH DID NOT PROGRAM, 101
FLASH NOT DETECTED, 179
NO DRAM DETECTED, 179
NVRAM FAILURE, 179
PROGRAM NEEDS MORE DRAM, 179
PROGRAM NEEDS MORE FLASH, 179
PROGRAM NOT COMPATIBLE, 179
PROGRAM NOT VALID, 101, 179
SECURITY PAL NOT DETECTED, 101, 179
SHORT AT ADDRESS XXXX, 101, 179
WRITING TO FLASH, 178, 180
Error log
clear, 135
print, 132
Error messages, 61
Error messages, list of, 62
ERROR OCCURRED / FLUSHING QUEUES*,
101, 180
ETHERNET ADAPTER BEING INITIALIZED, 101
ETHERNET DETECTED, 102
Ethernet interface assemblies
initialization procedure, 183
LEDs and DIP switches, 52
replacement, 207
F
Fan assembly
card cage, replacement, 209
hammer bank, replacement, 208,
210
Fault messages, 61
list of, 62
Fault symptoms
not from messages, 110
Flash memory
pre-written, part numbers for early models, 219
pre-written, part numbers for later models, 219
Flash memory, loading, 176
Flash messages
CLEARING PROGRAM FROM FLASH, 178
DIAGNOSTICS PASSED, 178
ERROR
DC PROGRAM NOT VALID, 178
DRAM AT ADDRESS XXXXXXXX, 178
EC PROGRAM NOT VALID, 178
EC STOPPED AT STATE XXXX, 178
FLASH NOT DETECTED, 179
NO DRAM DETECTED, 179
NVRAM FAILURE, 179
PROGRAM NEEDS MORE DRAM, 179
PROGRAM NEEDS MORE FLASH, 179
PROGRAM NOT COMPATIBLE, 179
PROGRAM NOT VALID, 179
SECURITY PAL NOT DETECTED, 179
SHORT AT ADDRESS XXXX, 179