IBM 6400 - Page 95

Message List
95
122 PAPER NOT
SCHEDULED
SEE USER’S GUIDE
The paper feed
process is not
scheduling on the
CMX controller board,
and the printer cannot
advance paper.
1. Cycle power. Run the print job again. If
the message appears, download the
emulation software again.
2. Cycle power. Run the print job again. If
the message appears, replace the MPU
cable assembly.
3. Power on the printer. Run the print job
again. If the message appears, replace
the power supply board.
4. Power on the printer. Run the print job
again. If the message appears, replace
the shuttle frame assembly.
5. Power on the printer. Run the print job
again. If the message appears, replace
the CMX controller board. Record the
message and return it with defective CMX
board.
123 PAPER BUSY TOO
LONG
SEE USER’S GUIDE
Firmware error on the
CMX controller board.
1. Cycle power. Run the print job again. If
the message appears, download the
emulation software again.
2. Run the print job again. If the message
appears, power off the printer. Remove
the paper guide assembly or pedestal top
cover. Make sure connectors P106 and
P107 are fully seated on the CMX
controller board.
3. Power on the printer. Run the print job
again. If the message appears, replace
the shuttle frame assembly.
4. Power on the printer. Run the print job
again. If the message appears, power off
the printer. Make sure the MPU cable, the
hammer bank logic cable, and the
hammer bank power cable are
undamaged and have good connections.
Replace as necessary. (Refer to
Appendix A.)
5. Power on the printer. Run the print job
again. If the message appears, replace
the CMX controller board. Record the
message and return it with defective CMX
board.
Table 4. Message List
Operator Panel
Message
Explanation Corrective Action