Table 1. Service Processor Checkpoints. (continued)
Checkpoint Description Action/ Possible Failing FRU
E023 Accessing memory card VPD Replace the memory card
Location: P1-M1
E025 Service processor accessing VPD. Replace the system board.
Location: P1
(See note 3 on page 115.)
E026 Service processor accessing VPD. Replace the system board.
Location: P1
(See note 3 on page 115.)
E030 Beginning to build I
2
C resources 1. Replace the processor card.
Location: P1-C1
2. Replace the system board.
Location: P1
(See note 3 on page 115.)
E031 Finished building I
2
C resources Replace the system board.
Location: P1
(See note 3 on page 115.)
E032 JTAG self-test Replace the system board.
Location: P1
(See note 3 on page 115.)
E040 Starting serial port tests Replace the system board.
Location: P1
(See note 3 on page 115.)
E042 Configuring serial port 1 Replace the system board.
Location: P1
(See note 3 on page 115.)
E043 Configuring serial port 2 Replace the system board.
Location: P1
(See note 3 on page 115.)
E044 Preparing to set serial port line speed Replace the system board.
Location: P1
(See note 3 on page 115.)
E045 Preparing to disconnect serial port Replace the system board.
Location: P1
(See note 3 on page 115.)
E050 Reading system VPD Operator panel.
Location: L1
(See note 2 on page 115.)
Chapter 4. Checkpoints
87
To Next Page
Loading...
