If this option is chosen, the following screen is displayed:
Do you wish to:
1. Make the rack/system indicator blink/reset the state
2. Clear all lightpath LEDs
98. Return to Previous Menu
1>>
If option 1 is chosen, the rack indicator/system attention LED can be set or reset
(turned on or off).
If option 2 is chosen, the LEDs on the lightpath LED panel can be cleared (turned
off).
Note: The system fault/system identify LED can also be set and reset using tasks in
the AIX Service Aids.
Language Selection Menu
The service processor menus and messages are available in different languages. This
menu allows selecting languages in which service processor and system firmware
menus and messages display.
LANGUAGE SELECTION MENU
1. English
2. Francais
3. Deutsch
4. Italiano
5. Espanol
6. Svenska
98. Return to Previous Menu
99. Exit from Menus
1>
Note: Your ASCII terminal must support the ISO-8859 character set to correctly display
languages other than English.
Chapter 7. Using the Service Processor 199
To Next Page
Loading...
