IBM 6C1 - Setup Remote IPL (Initial Program Load)

Setup Remote IPL (Initial Program Load)
This option allows you to enable and set up the remote startup capability of your
system unit. You must first specify the network parameters.
Network Parameters
1. IP Parameters
2. Adapter Parameters
3. Ping
--------------------------------------------------------------------------------------------------
Navigator keys:
M = return to main menu
ESC key = return to previous screen X = eXit System Management Services
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigator key: _
Selecting the IP (Internet Protocol) Parameters option displays the following screen.
IP Parameters
1. Client IP Address [000.000.000.000]
2. Server IP Address [000.000.000.000]
3. Gateway IP Address [000.000.000.000]
4. Subnet Mask [255.255.255.000]
--------------------------------------------------------------------------------------------------
Navigator keys:
M = return to main menu
ESC key = return to previous screen X = eXit System Management Services
--------------------------------------------------------------------------------------------------
Type the number of the menu item and press Enter or Select a Navigator key: _
To change IP parameters, type the number of the parameters for which you want to
change the value.
Attention: If the client system and the server are on the same subnet, set the
gateway IP address to [0.0.0.0].
Chapter 8. Using System Management Services 243