Replacement
1. Install the hard disk drive in the hot-swap bay:
a. Ensure the tray handle is open (perpendicular to the drive).
b. Align the drive/tray assembly so that it engages the guide rails in the bay.
c. Push the drive assembly into the bay until the tray handle engages the lock
mechanism.
d. Push the tray handle to the right until it locks.
2. Check the disk drive status indicators to verify that the hard disk drive is installed
properly.
3. If the system is a Model 6E1, close and lock the system door.
300 Service Guide
To Next Page
Loading...
