Table 2. Firmware Checkpoints. (continued)
Checkpoint Description Action/ Possible Failing FRU
E177 Transfer failure due to TFTP error
condition
Refer to “Boot Problems/Concerns” on
page 110 for general considerations.
1. Turn off, then on, and retry the boot
operation.
2. Verify boot list by using the firmware
SMS Multiboot menus.
3. Verify the network connection
(network could be down).
4. Have network administrator verify
the server configuration for this
client.
E178 Create PCI token ring node Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E17B Processor frequency measurement
1. Replace battery, restore NVRAM
data (passwords, startup data)
2. Replace the system board.
Location: P1
See note 3 on page 115.
E180 Service processor command setup Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E183 Service Processor POST Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E190 Create ISA node Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E193 Initialize Super I/O. Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E196 Probe ISA bus. Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E19B Create service processor node. Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E19C Create tablet node. Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E19D Create NVRAM node. Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
E19E Real time clock (RTC) creation and
initialization.
Go to MAP 1540: Minimum
Configuration, “Step 1540-24” on
page 81.
100 Service Guide
To Next Page
Loading...
