Step 1540-13
The system is working correctly with this configuration. One of the disk drives that you
removed is removed from the disk drive cage may be defective.
1. Make sure the diagnostic CD-ROM is inserted into the CD-ROM drive.
2. Turn off the power and remove the power cords.
3. Install a disk drive in the disk drive cage.
4. Plug in the power cords and wait for OK on the operator panel display.
5. Turn on the power.
6. After the keyboard indicator is displayed, press the F5 key on the directly attached
keyboard or the number 5 key on an ASCII terminal keyboard.
7. Enter the appropriate password if you are prompted to do so.
Is the ″Please define the System Console″ screen displayed?
No In the following order, exchange the FRUs that have not been exchanged:
1. Last disk drive installed
2. Disk drive cage backplane
Repeat this step until the defective FRU is identified or all the FRUs have been
exchanged.
If the symptom did not change and all the FRUs have been exchanged, call
service support for assistance.
If the symptom has changed, check for loose cards, cables, and obvious
problems. If you do not find a problem, return to “Step 1540-1” on page 64 in
this MAP and follow the instructions for the new symptom.
Yes Repeat this step until all drives are installed and tested.
Go to “Step 1540-14” on page 75.
74 Service Guide
To Next Page
Loading...
