Step 1540-16
The system is working correctly with this configuration. One of the FRUs (adapters) that
you removed may be defective.
1. Turn off the power and remove the power cords.
2. Install a FRU (adapter) and connect any cables and devices that were attached to
the FRU.
3. Plug in the power cords and wait for OK on the operator panel display.
4. Turn on the power.
5. If the Console Selection screen is displayed, choose the system console.
6. After the keyboard indicator displays, press the F5 key on the directly attached
keyboard or the number 5 key on an ASCII terminal keyboard.
7. Enter the appropriate password if you are prompted to do so.
Is the ″Please define the System Console″ screen displayed?
NO Go to “Step 1540-17” on page 78.
YES Repeat this step until all of the FRUs (adapters) are installed.
Go to ″MAP 0410: Repair Checkout″ in the
RS/6000
Eserver
pSeries
Diagnostic Information for Multiple Bus Systems
.
Chapter 3. Maintenance Analysis Procedures (MAPs) 77
To Next Page
Loading...
