7-6
Rev AA
Printhead does
not drive
Condition of the belt drive
and pulleys
Check and correct
Printhead stepper motor
not plugged in securely
Check and correct
Linear slide carriage
jammed
Turn the power off. Try to
move the linear slide. If
jammed, clear the
obstruction.
Incorrect tension on the
timing belt
Re-tension the timing belt
Faulty Motor Check the motor and replace
it, if necessary
Error
Message
Possible Causes Remedies
Table 7-1: Error Messages and Remedies (Continued)
ICE Pegasus Service Manual
To Next Page
Loading...
Need help?
General
