Ice PegasusHS User Manual

Rev AA 7-7
No information is
printed
Insufficient or no air
pressure
Check and set the air
pressure to 3 bar
No Print Signal Go to: Tools/Diagnostics/
Printhead/Inputs and check
the presence of incoming
print signal.
Low Darkness level Go to: Tools/Setup/Printhead
and increase the Darkness
setting.
Continuous Mode Only:
Incorrect or No Encoder
signal
Go to: Tools/Diagnostics/
Printhead/Inputs and check
for free encoder wheel
rotation, “Forward” direction
and incoming signal.
Continuous Mode Only:
Incorrect “Print Position”
parameter
Go to: Tools/Setup/Printhead
and check the print position
to ensure optimum printhead
position directly over the
roller centerline. Parameter
should be about: 2100 for
right-hand units 2500 for left-
hand units.
Intermittent Mode Only:
Substrate is moving while
attempting to print
Print signal timing is
incorrect. If necessary, delay
the print until the film stops
and settles (Dwell Time) by
entering a “Print Delay”
value.
Go to: Tools/Setup/Printhead
Intermittent Mode Only:
Incorrect Print Speed
Go to: Tools/Setup/
Printhead. Check and
correct the print speed.
Printhead not contacting
the print platen or roller
Check and correct any
obstructions
No information is
printed
Incorrect Vertical
Registration
Set Vertical Registration to 0
Faulty Printhead Replace the printhead
Production line speed fell
below 40mm/sec
Confirm minimum speed. Go
to: Tools/Diagnostics/
Printhead/Timings and
increase the line speed
Error
Message
Possible Causes Remedies
Table 7-1: Error Messages and Remedies (Continued)
ICE P
egasus Service Manual

Ice PegasusHS Specifications

General

Brand	Ice
Model	PegasusHS
Category	Printer
Language	English