1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
D Comment
Program up to a 43-character* comment. The programmed
comment is transmitted with the GPS position data.
*36-character comment can only be programmed when
“COURSE/SPEED” is selected in data extension.
q Push [
](5)
†
twice to enter programming condition.
w Rotate [DIAL] to select the desired character.
• The selected character blinks.
• Push [A/a](3) to change the character group from “AB” (alphabeti-
cal characters; capital letters), “ab” (alphabetical characters; lower
case letters), “12” (numbers) and “ !” ” (symbols) in sequence.
• Push [
](6) to move the cursor right; push [ ](4) to move the
cursor left.
• Push [CLR](1) to erase the selected character, or push and
hold [CLR](1) for 1 sec. to erase all characters following the
cursor.
e Repeat step w until the desired channel name is pro-
grammed.
r Push [
](5)
†
to program the comment and exit comment
programming condition.
t Push [
](4) to return to GPS-A SET screen mode.
D GPS auto TX timer
Selects the desired interval for automatic position transmis-
sion function from 5, 10, 30 second, 1, 3, 5, 10 and 30 min-
utes.
D DV auto detect
When a signal other than DV mode is received during DV
mode operation, the transceiver has capability of automatic
FM mode selection.
• OFF : Operating mode is fi xed in DV.
(default)
• ON : The transceiver automatically selects FM
mode for temporary operation.
To Next Page
Loading...
