■ Scan resume condition
D Scan pause timer
The scan pauses when receiving signals according to the
scan pause time. It can be set from 2 to 20 sec. or unlimited.
q Enter “PAUSE” in scan set mode.
(p. 96)
w Rotate [DIAL]
†
to set the desired scan pausing time from
2–20 sec. (2 sec. steps) or “HOLD.”
• “2SEC”–“20SEC” :- Scan pauses for 2–20 sec. while receiving a
signal.
• “HOLD” :- Scan pauses on a received a signal until it
disappears.
e Push [ ](5) (or [ ](4)) to return to scan set mode.
r [MENU/
] to return to frequency indication.
D Scan resume timer
The scan restarts after the signal disappears according to
the resume time. It can be set from 0–5 sec. or unlimited.
q Enter “RESUME” in scan set mode.
(p. 96)
w Rotate [DIAL]
†
to set the desired scan resume time from
0–5 sec. (1 sec. steps) and “HOLD.”
• “0SEC” :- Scan restarts immediately after the signal
disappears.
• “1SEC”–“5SEC” :- Scan restarts 1–5 sec. after the signal disap-
pears.
• “HOLD” :- Scan restarts by rotating [DIAL] only.
e Push [ ](5) (or [ ](4)) to return to scan set mode.
r [MENU/
] to return to frequency indication.
Scan resume timer must be set shorter than the scan
pause timer, otherwise this timer does not activate.
89
9
SCAN OPERATION
To Next Page
