■ Memory clearing
Contents of programmed memories can be cleared
(blanked), if desired.
q Push and hold [S.MW](MR) for 1 sec. to enter select
memory write mode.
• 1 short and 1 long beeps sound.
• “μ ” indicator blinks.
• Do not hold [S.MW](MR) for more than 2 sec. otherwise the
memory contents will be copied to VFO.
w Rotate [DIAL] to select the desired memory channel to be
cleared.
e Push [∫](2) or [√](8) to select “CLEAR.”
r Push and hold [S.MW](MR) for 1 sec. to clear the con-
tents.
• 3 beeps sound.
• The cleared channel changes to blank channel
• Return to select memory write mode.— “μ ” indicator blinks.
Push [VFO] to exit select memory write mode.
NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled.
To Next Page
Loading...
