Icom IC-92A - Power Save

129
12
OTHER FUNCTIONS
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
y When the alert is detected, a beep sounds and the follow-
ing indication will be displayed.
u Turn the weather alert function OFF in set mode.
NOTE: While receiving a signal (on a frequency other
than the weather alert ON frequency), the receiving signal
or audio will be interrupted momentarily every 5 sec.
(ap-
prox.)
in the case that the alert function is turned ON. This
symptom is caused by the WX alert function. To cancel
these symptoms, set the weather alert item OFF in set
mode.
■ Power save
The power save function reduces the current drain to con-
serve battery power.
The power save duty cycle, the ratio of receive circuit on
to receive circuit off during standby, can be set to auto-
matic
(default), 1 : 1 (150 msec. : 150msec.), 1 : 4 (150 msec. :
600msec.)
, 1 : 8 (150 msec. : 1200msec.) or OFF with “POWER
SAVE” in set mode.
(p. 88)
• “AUTO” selects “1:1” duty ratio when receiving no signal for 5 sec.,
then “1:4” 60 sec. after that.
The ratio becomes “1:8” when no sig-
nal is received for another 60 sec.
A
WX
1
WX
A
WX
1
WXWX
A
WXWX
1
ALTALT
Shows above indications alternately
❮MENU screen❯ ➪ ❮SET MODE❯ ➪ ❮POWER SAVE❯
(Push [MENU/
]) (Rotate [DIAL]
†
, then push [ ](5)
†
.)
150 msec.
150 msec.
60 sec.
60 sec.
600 msec.
1200 msec.
No signal
5 sec.
Circuit ON
Circuit OFF
†
[DIAL] ↔ [ ](2)/[ ](8) [ ](5) ↔ [ ](6)