Icom IC-92A - 1 Accessory Attachment; Antenna; Belt Clip; Handstrap

1
1
ACCESSORY ATTACHMENT
1
■ Antenna
Insert the supplied antenna into the
antenna connector and screw down
the antenna as shown at left.
NEVER carry the transceiver by
holding the antenna.
KEEP the jack cover attached when
jack is not in use to protect the con-
nector from dust and moisture.
✔ For your information
Third-party antennas may increase transceiver perform-
ance. An optional AD-92SMA
ANTENNA CONNECTOR
ADAPTER is available to connect an antenna with a BNC
connector.
■ Belt clip
■ Handstrap
Slide the handstrap through the
loop on the top of the belt clip as
illustrated at left to facilitate carrying
the transceiver.
■ Battery pack
Attach the Li-Ion battery pack (BP-217) or battery case
(BP-216) as illustrated below.
• Charge the Li-Ion battery pack before use. (pgs. 10, 11)
Jack cover
Handstrap
Supplied screws*
*NOTE:
USE the supplied screws
only. Using screws
longer than specified
could damage the
q
w
Battery pack
/
Battery case
Latch