■ Scan set mode items
D Priority watch
Activates priority watch or priority watch with alert (Bell).
• OFF : The priority watch is turned OFF.
(default)
• ON : The transceiver checks the memory channel fre-
quency every 5 sec.
• B ELL : The transceiver checks the memory channel
frequency every 5 sec. You can be alerted with
beeps and blinking “S.”
D Scan pause timer
Selects the scan pause time. When receiving signals, the
scan pauses according to the scan pause time.
• 2–20 SEC : Scan pauses for 2–20 sec. on a received
signal in 2 sec. steps.
(default: 10 sec.)
• HOLD : Scan pauses on a received signal until it
disappears. Rotate [DIAL] to resume man-
ually.
D Scan resume timer
Selects the scan resume time from a paused frequency after
the received signal disappears.
• 0 : Scan resumes when a received signal disap-
pears.
• 1–5 SEC : Scan pauses 1–5 sec. after a received signal
disappears.
(default: 2 sec.)
• HOLD : Scan pauses on the received signal even if it
disappears. Rotate [DIAL]
†
to resume manu-
ally.
Scan resume timer must be set shorter than scan pause
timer
(previous item), otherwise this timer does not activate.
To Next Page
Loading...
