MEMORY/CALL CHANNELS
9
■ General description
The IC-92A/92AD has 850 memory channels in A band, 450
memory channels in B band, and 2 call channels in each
band. Memory channels in each bands including 50 scan
edge memory channels
(25 pairs) for storage of often-used
frequencies, respectively.
And a total of 26 memory banks, A to Z, are available in
each bands for storing groups of frequencies, etc. Up to 100
channels can be assigned into a bank.
D Memory channel contents
The following information can be programmed into memory
channels:
• Operating frequency
(p. 18)
• Operating mode (p. 21)
• Duplex direction (+DUP or –DUP) with an offset fre-
quency
(p. 31)
• Subaudible tone encoder (p. 107), tone squelch or
DTCS squelch ON/OFF
(p. 110)
• Subaudible tone frequency (p. 107), tone squelch fre-
quency or DTCS code with polarity
(pgs. 107, 111)
• Scan skip information (p. 80)
• Memory bank (p. 67)
• Memory name (p. 70)
• Tuning step (p. 18)
• Call sign squelch or Digital code squelch* (p. 110)
• Station call sign* (p. 36)
• RPT1/RPT2 call sign* (p. 41)
*Available for B band operation only.
■ Selecting a memory channel
D Using [DIAL]— Programmed channels
q Push [MR] to select memory mode.
w Rotate [DIAL] to select the desired memory channel.
• Only programmed channels are displayed.
D Using [DIAL]— All channels
q Push [MR] to select memory mode.
w Push and hold [S.MW](MR) for 1 sec. to enter select
memory write mode.
• 1 short and 1 long beep sound.
• “μ ” indicator blinks.
e Rotate [DIAL] to select the desired memory channel.
• All channels are displayed.
• Push [VFO] to return to memory mode indication.
To Next Page
Loading...
