1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Cloning function
The IC-92A/92AD has transceiver-to-transceiver data clon-
ing capability. This function is useful when you want to copy
all of the programmed contents from one IC-92A/92AD to
another.
• An optional OPC-474
CLONING CABLE is required.
q Turn the transceiver’s power OFF, then connect an op-
tional OPC-474 between both [SP] jacks.
w While pushing [MR] and [MENU/
], push and hold
[PWR] for 1 sec. to enter cloning mode.
• “CLONE M” appears.
e Push [PTT] on the “master” transceiver.
• “CLONE OUT M” appears and the bar meter shows that cloning
is taking place.
• After the cloning is completed, the display returns to “CLONE
M.”
r Push and hold [PWR] for 1 sec. to turn power OFF.
The optional RS-92
REMOTE CONTROL SOFTWARE is also
available to clone/edit contents with a PC (for Microsoft
®
Windows
®
98/98SE/ME/2000XP) and using ICF format fi les.
Microsoft
®
and Windows
®
are registered trademarks of Microsoft Corporation
in the U.S.A. and other countries.
■ [DATA/MIC/SP] jacks
To connect external equipment such as speaker, micro-
phone, TNC, etc. refer to the diagram below.
The center terminal of [MIC] outputs 3.3 V DC via 330
resistor.
To Next Page
Loading...
