■ Received call sign
When a call is received in DV mode, the calling station and
the repeater call signs being used can be stored into the re-
ceived call record. The stored call signs are viewable in the
following manner.
Up to 20 calls can be recorded.
D Desired call record indication
q Enter RX call sign set mode.
• RX CALL SIGN screen is displayed.
w Rotate [DIAL]
†
to select the desired record channel.
e To confirm the received call, push [
](5) several times
to select the desired call sign from CALLER, CALLED,
RXRPT1 and RXRPT2.
CALLER : The station call sign that made a call.
CALLED : The station call sign called by the caller.
RXRPT1 : The repeater call sign used by the caller station.
RXRPT2 : The repeater call sign linked from RXRPT1.
r Push [MENU/ ] to return to frequency indication.
NOTE: When a call is received in DV mode when the
power save function is activated, the call sign may not be
received correctly.
This is normal, not a malfunction, because of header of
the call sign cannot be detected during power save.
Turn the power save function OFF
(p. 115) if you want to
receive a call sign correctly even in stand-by condition.
✔ For your information
When receiving a call, the received station call sign is auto-
matically displayed and scrolled in sequence at the bottom
line of the function display.
This can be turned OFF in display set mode.
(p.100)
†
[DIAL] ↔ [ ](2)/[ ](8) [ ](5) ↔ [ ](6)
❮MENU screen❯ ➪ ❮RX CALL SIGN❯
(Push [MENU/
]) (Rotate [DIAL]
†
, then push [ ](5)
†
.)
To Next Page
Loading...
