■ Copying the call sign
D Copying the call sign memory contents
This function is convenient when or modifying a part of the
current call sign.
NOTE: Make sure that the “EDIT RECORD” item in DV
set mode is set to “AUTO” or “SELECT” in advance.
(p. 95)
q During DV mode operation, enter call sign set mode.
• CALL SIGN screen is displayed.
w Rotate [DIAL]
†
to select “UR,” “R1” or “R2” as desired,
then push [
](5)
†
.
e Rotate [DIAL]
†
to select the desired call sign channel to
be copied.
• U01–U60 and R01–R60 are available.
• When “AUTO” is set to “EDIT RECORD” item
r Push [ ](6) to select the call sign programming mode.
• A blank channel is selected automatically.
• The 1st digit of the selected call sign blinks.
t Edit or modify the selected call sign as described in “D
Station call sign programming”
(p. 36) or “D Repeater call
sign programming”
(p. 41).
y Push [
](5) to store the edited/modifi ed call sign into the
selected blank channel.
NOTE: The message “FULL” is displayed when no blank
channel is available in station or repeater call sign mem-
ory.
Select the desired call sign channel number as described
in step u of “• When “SELECT” is set to “EDIT RECORD”
item” at right-hand page in this case.
❮MENU screen❯ ➪ ❮CALL SIGN❯
(Push [MENU/
]) (Rotate [DIAL]
†
, then push [ ](5)
†
.)
U21
To Next Page
Loading...
