1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
D GPS-A Set mode
Entering to GPS-A set mode for GPS-A operation when sse-
lect “GPS-A” in GPS TX mode item, then push [
](5)
†
. This
set mode is available to set unproto address, data extension,
time stamp, GPS-A symbol and comment.
D Unproto Address
56 characters can be entered for unproto address.
q Push [
](5)
†
to enter the unproto address edit mode.
w Rotate [DIAL]
†
to select the desired character.
• The selected character blinks.
• Push [A/a](3) to change the character group from “AB” (alphabeti-
cal characters; capital letters), “ab” (alphabetical characters; lower
case letters), “12” (numbers) and “ !” ” (symbols) in sequence.
• Push [
](6) to move the cursor right; push [ ](4) to move the
cursor left.
• Push [CLR](1) to erase the selected character, or push and
hold [CLR](1) for 1 sec. to erase all characters following the
cursor.
e Repeat step w until the desired channel name is pro-
grammed.
r Push [
](5)
†
to program the unproto address and exit the
unproto address edit mode.
D DATA Extension
Sets the data extension capability from “COURSE/SPEED”
and OFF (default).
The transceiver’s course and speed information is addition-
ally transmitted with position data when “COURSE/SPEED”
is selected.
NOTE: When “COURSE/SPEED” is selected, number of
character for “COMMENT” is limited to 36-character.
To Next Page
Loading...
