1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Skip channel/frequency setting
Memory channels can be set to be skipped for memory skip
scan. In addition, memory channels can be set to be skipped
for both memory skip scan and frequency skip scan. These
are useful to speed up the scan rate.
q Select a memory channel:
➥ Push [MR] to select memory mode.
➥ Rotate [DIAL] to select the desired channel to be a
skip channel/frequency.
w Push and hold [S.MW](MR) for 1 sec. to enter select
memory write mode.
e Push [∫](2) or [√](8) several times to select “SKIP.”
r Rotate [DIAL] to select the skip condition from “SKIP,”
“P SKIP” or “OFF” for the selected channel.
• P SKIP : The channel is skipped during memory/bank scan and
the programmed frequency is skipped during VFO
scan, such as programmed scan.
• SKIP : The channel is skipped during memory or bank scan.
• OFF : The channel is scanned during any scan.
(Continue to the next page.)
FM
To Next Page
Loading...
