Icom IC-92A - Page 11

5
2
PANEL DESCRIPTION
New2001
2
9
DTMF . M
CS
0
CQ
.
T.SCAN
CD
#
REC
MODE
KEY Pushed momentarily Pushed and held for 1 sec.
• Inputs digit ‘7’ for frequency input, memory channel selection,
etc.
• While pushing [PTT], this key sends the DTMF code “7.”
• Inputs digit ‘8’ for frequency input, memory channel selection,
etc.
• While pushing [PTT], this key sends the DTMF code “8.”
• Inputs digit ‘9’ for frequency input, memory channel selection,
etc.
• While pushing [PTT], this key sends the DTMF code “9.”
• Inputs digit ‘0’ for frequency input, memory channel selection,
etc.
• While pushing [PTT], this key sends the DTMF code “0.”
• Inputs MHz digit for frequency input.
• While pushing [PTT], this key sends the DTMF code “F (#).”
• During DV mode operation, selects the record track for voice
memory. (p. 62)
• While pushing [PTT], this key sends the DTMF code “E (✱).”
• During FM/FM-N mode operation, selects repeater tone, tone
squelch, DTCS squelch and no tone operation in sequence.
(p. 110)
• During DV mode operation, selects digital call sign, digital code
and no tone operation in sequence. (p. 110)
• Selects tuning step selection. (p. 18)
• Select DTMF memory mode. (p. 103)
• During DV mode operation, CALL SIGN setting mode is dis-
played. (p. 51)
• During DV mode operation, set “CQCQCQ” for station’s call
sign for operation.
• During FM/FM-N mode operation, starts tone scan function.
(p. 112)
• During DV mode operation, RX CALL SIGN is displayed. (p. 56)
• Selects the operating mode.
7
TONE
DSQ
8
TS