5
2
PANEL DESCRIPTION
New2001
2
KEY Pushed momentarily Pushed and held for 1 sec.
• Inputs digit ‘7’ for frequency input, memory channel selection,
etc.
• While pushing [PTT], this key sends the DTMF code “7.”
• During FM/FM-N mode operation, selects repeater tone, tone
squelch, tone squelch reverse, DTCS squelch, DTCS squelch re-
verse and no tone operation in sequence. (p. 124)
• During DV mode operation, selects digital call sign squelch, digital
code squelch and no squelch operation in sequence. (p. 124)
• Inputs digit ‘8’ for frequency input, memory channel selection,
etc.
• While pushing [PTT], this key sends the DTMF code “8.”
• Selects tuning step selection. (p. 18)
• Inputs digit ‘9’ for frequency input, memory channel selection,
etc.
• While pushing [PTT], this key sends the DTMF code “9.”
• Select DTMF memory mode. (p. 117)
(Push and hold for 2 sec. while operating DV mode.)
• During DV mode operation, CALL SIGN setting mode is displayed.
(pgs. 38, 48)
• Inputs digit ‘0’ for frequency input, memory channel selection,
etc.
• While pushing [PTT], this key sends the DTMF code “0.”
• During DV mode operation, set “CQCQCQ” for station’s call sign
for operation.
• Inputs MHz digit for frequency input.
• While pushing [PTT], this key sends the DTMF code “F (#).”
• During FM/FM-N mode operation, starts tone scan function.
(p. 126)
• During DV mode operation, RX CALL SIGN is displayed. (p. 46)
• During DV mode operation, selects the record track for voice
memory. (p. 66)
• While pushing [PTT], this key sends the DTMF code “E (✱).”
• Selects the operating mode. (p. 21)
9
DTMF
.
M
CS
0
CQ
.
T.SCAN
CD
#
REC
MODE
7
TONE
DSQ
8
TS
To Next Page
Loading...
Need help?
General
