EasyManuals Logo

Icom IC-92A User Manual

Icom IC-92A
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
New2001
iv
NOTICES
D Using the optional HM-175GPS
Noise signals from the HM-175GPS may interfere with the
IC-92AD's AM radio or HF band reception.
In this case, set the HM-175GPS’s microphone cable as
distant to the antenna as far as possible, or turn off the HM-
175GPS.
D Data output from HM-175GPS
The optional HM-175GPS outputs GPS data (position data,
etc.) to IC-92AD at intervals while receiving only.
Therefore, the transceiver is not updated GPS data while
transmitting.
The transceiver transmits GPS data that was received prior
to the last IC-92AD DV mode transmit.
D About OPC-1797
NEVER connect the optional OPC-1797 CONNECTION CABLE
with non-Icom article specifi ed.
When connecting a monaural plug to 2.5 (d) mm, it acts as
short and becomes a cause of failure.
Turn power OFF when connecting or disconnecting the
OPC-1797.
Icom, Icom Inc. and the
logo are registered trademarks of Icom
Incorporated (Japan) in the United States, the United Kingdom,
Germany, France, Spain, Russia and/or other countries.
APRS
®
is a registered trademark of Mr. Bob Bruninga in the U.S.A.
and other countries.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Microsoft, Windows and Windows Vista are either registered trade-
marks or trademarks of Microsoft Corporation in the United States
and/or other countries.

Table of Contents

Other manuals for Icom IC-92A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-92A and is the answer not in the manual?

Icom IC-92A Specifications

General IconGeneral
BrandIcom
ModelIC-92A
CategoryTransceiver
LanguageEnglish

Related product manuals