SET MODE
7
7
7-5
When you set the system language of the linear
capability to display both English and Japanese
characters. However, if you select Japanese, all
displayed only Japanese characters.
There will be no English item names. Unless you
feature with extreme caution.
Japanese and do not understand the menu system
in the new setting, you will have to change the
language back to English by doing a partial reset of
call sign databases.
To do a partial reset of the CPU, do the following
steps:
1. Push
.
2. Touch [SET].
3. Touch the item (with the “etc.” icon) shown below.
4. Touch the bottom item shown below.
5. Touch the upper item shown below.
6. Touch the left item.
•
partial reset is completed.
System Language (Default: English)
•
English.
Only alphabetical characters (A to Z,
a to z, 0 to 9) and symbols (! “ # $ %
& ‘ ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ `
{ | } ~) can be displayed. If Japanese
characters (Kanji, Hiragana, and
Katakana) are included, the display
shows “=” or “_” instead of that
character. In that case, you can only
mode.
•
Japanese.
Kanji, Hiragana, and Katakana
characters and the 2-bytes symbols
can be displayed. To display such
characters in the Menu screen, set
“Display Language” to “Japanese.”
L When this item is set to “English,” the “Display Language”
item is not displayed.
To Next Page
Loading...
