Icom IC-PW2 - Network; Display

7
SET MODE
7-4
MENU
»
SET > Display
LCD Backlight (Default: 50%)
Sets the LCD backlight brightness.
LED Bright (Default: 80%)
Sets the LED brightness.
Meter Response (Default: Mid)
Sets the meter needle response speed to Slow, Mid,

Meter Peak Hold (Default: ON)

L When the function is turned ON, the indicated value at the
time of the largest swing when using the multi-function
meter is held for 0.5 seconds.
Screen Saver (Default: 60min)
Sets the Screen Saver function.
L When no operation is performed for the preset period

indicator on
POWER
blinks blue.
To display the screen, push any key or touch the screen.
Opening Message (Default: ON)
Selects whether or not to display the opening
message at power ON.
My Call
Displays text as the opening message, up to 10
characters. (p. 8-4)
Temperature Unit

L 󰀨

Select the format to display the temperature.
Display Language (Default: English)
Set the screen display language type to English or
Japanese.
L This item is displayed only when the “System Language”
item is set to “Japanese.”
DisplayNetwork
MENU
»
SET > Network
DHCP (Valid after Restart) (Default: ON)

• 
• ON: Uses the DHCP function.
If a DHCP server is in your network
environment, the IP address is automatically
obtained.
IP Address (Valid after Restart)
(Default: 192.168. 0. 10)
Sets the static IP address.
Subnet Mask (Valid after Restart)
(Default: 255.255.255. 0 (24 bit))
Sets the subnet mask to connect to your PC or Local
Area Network (LAN), through the Ethernet.
Default Gateway (Valid after Restart) (Default: . . . .)
Sets the Default Gateway of the IC-PW2.
If you are operating the IC-PW2 using the optional
remote control software*, a default gateway setting is
required.

Primary DNS Server (Valid after Restart)
(Default: . . . .)
Enter the primary DNS server address.
2nd DNS Server (Valid after Restart)
(Default: . . . .)
If there are 2 DNS server addresses, enter the
secondary DNS server address.
Network Name
If you are operating the IC-PW2 using the optional
remote control software*, enter a name of up to 15
characters.

L See page 1-8 for details on entering characters.