9-1
9
MAINTENANCE
Occasionally, erroneous information may be
displayed. This may be caused by static electricity or
by other factors.
If the problem still exists, perform a Partial reset, as
described to the right.
If the problem still exists after a Partial reset, perform
NOTE:
settings to factory defaults. Save antenna memory
contents, setting status, and so on, onto an SD card
Partial reset
Partial reset resets operating settings to their default
without clearing the items listed below:
•
• The ON/OFF setting of the internal antenna tuner
• Preset points for fast tuning
• Network settings
• My Call setting
•
•
•
All reset
factory defaults.
and so on will all be cleared, so you will need to
rewrite your operating settings unless you have a
backup.
TIP:
• To delete all the preset points for fast tuning, do it
from the following item.
»
SET > Function >
<<Tuner Preset Memory Clear>>
• If a touch screen operation error or an unexpected
operation occurs, you cannot enter the Set mode.
below:
1. Turn OFF the linear amplifier.
While holding down
and
,
push
.
L
using
and
.
D Partial reset
1. Open the RESET screen.
»
SET > Others > Reset
Touch “Partial Reset.”
•
3. Touch [YES].
L
D All reset
1. Open the RESET screen.
3. Touch [NEXT].
4.
L
Resetting
To Next Page
Loading...
